الصورة الكبيرة
At the end of the opening type sampler-Solid particle sampler-China mechanical equipment (Zhengzhou) Co., Ltd.
China mechanical equipment (Zhengzhou) Co., Ltd. to provide you with a large number of Zhengzhou maize sampler,Grain sampler,Zhengzhou sampler, at the same time you can free a complete sampling solutions, to meet your needs, application of a wide range of products, such as can not meet your specific requirements, can also according to your specific requirements custom-made
model：BTZ-K
At the end of the opening type sampler with6679-2003 GB/TGeneral rules for the sampling of solid chemical products, applicable to: powder, small particles, small crystals and other materials are less than the diameter of5MMFor diameter greater than5MMSolid sampling probe capable of special processing) solid sampling of chemical products. Material: stainless steel, diameter25MMLength800MMSlot.Nineteen×715MM.
Another: a closed sampling probe tip closed sampler attached bottle sampler window closed sampler Click to view the relevant product information
At the end of the opening type sampler features:
OneMaterialThree hundred and fourStainless steel, no pollution to the sample, widely used in pharmaceutical, food and other industries.
TwoThe sampling probe. The inner wall and the outer wall polishing treatment, can prevent the contamination of the sample and easier to clean.
ThreeThe sampling probe. All parts can be disassembled, easy to clean, can prevent the remaining bacteria and pollutants.
Product selection:For loose solid sample sampling level: end closed sampler, an end opening of the sampler, the window is closed sampler. If the vertical sampling the sampling probe inserted into the material along the diagonal direction.
For solid sample thick can choose: universal sampling probe. The unique design of the universal type sampling probe, both horizontal or vertical sampling for sampling.
instructions: 1Before use, should check whether the sampling probe cleaning.
TwoThe sampling probe inserted into the notch downward along a certain angle material, reach the designated depth after rotation2-3Time, careful sampling probe pulled back, pay attention to withdraw when sampling probe slot should be upward, and the sampling probe material into the sample container.
ThreeIf the material is not loose, the discharge from the sampling probe inserted into the rear end of the push rod material smoothly into the sample container.
FourThe sampling probe clean, complete sampling.
